2WA/2NJ/2RK
4-214
(10-5) Adjusting the angle of leading edge
Perform the following adjustment if the leading edge of the copy image is laterally skewed.
Procedures
1. Place an original on the DP and press-
the [start] key to make a test copy.
2. If the gap of leading edge exceeds
theRefer ence value, perform the fol-
lowingadjustment.
Refer ence value
For simplex copying: Within ±3.0 mm
For duplex copying: Within ±4.0 mm
Figure 4-325
3. Loosen two screws (b) of right and left
fixing fittings (a).
Figure 4-326
Original
Copy Sample1 Copy Sample2
3mm/4mm 3mm/4mm
14j0511
To Next Page
Loading...
