Kyocera TASKalfa 8002i

2NJ/2RK
2-14
(7) Release the lock of developer waste outlet
Caution
To ease setup, the device was shipped with the
developer unit already replenished with developer.
Therefore, to prevent developer from spilling during
shipping, a developer shutter is equipped with the
developer unit.
To disengage the shutter, use the following proce-
dure: Note that if the shutter is not completely disen-
gaged and retained in place, the developer in the
developer unit may clog at the outlet causing a dam-
age to the developer unit.
1. Remove two tapes(a) and then remove the set up
leaflet(b).
*: The setup leaflet must be affixed in position before
dispatching the machine.
2. Open the waste toner box cover(c).
Figure 2-18
3. Pull the paper conveying unit(a) out.
4. Remove one screw (b)(M4x8).
Figure 2-19
a
b
a
c
a
12j0143a
b