2NJ/2RK
2-131
(11)Coin Vendor (100V model only)
Coin vendor installation requires the following parts:
Coin Vendor (1905H99JP0) 1 pc
Vendor relay wire (302RH4622_)1 pc
Bundled parts of Coin Vendor (1905H99JP0)
Vendor wire 1 pc
Vender base 1 pc
Screws (M4x6) 4 pcs
Procedures
1. Turn the power switch off and disconnect the power plug.
2. Attach the vendor base (b) to coin vendor (c) with four
screws (a)(M4x6).
Figure 2-245
3. Slide the controller cover (a) in the direction of the arrow and detach it.
Figure 2-246
a
b
c
a
a
To Next Page
Loading...
