Kyocera TASKalfa 8002i

2WA/2NJ/2RK
4-121
(4) Drive section
(4-1) Detaching and reattaching the drum drive unit
Procedures
1. Remove the developer unit. (Refer 1-4-
33)
2. Detach the drum unit. (Refer 1-4-35)
3. Remove the rear left cover, rear right
cover and rear lower cover. (Refer 1-4-
72)
4. Remove the feed PWB assembly.
(Refer 1-4-35)
5. Disconnect the connector (a).
6. Release the wire saddle (b).
Figure 4-181
7. Remove three screws (a)(M4x8).
8. Detach the drum drive unit (b).
*: Do not hold the only shaft part (c), when
carrying the drum drive unit (b). (Have
the housing (b).)
*: Put support on the tip of the shaft so
that the shaft (c) may become the hori-
zontal when putting the drum drive unit
(b) on the table etc.
Figure 4-182
b
a
14j0600
b
a
14j0601
a
a
c