Kyocera TASKalfa 8002i

2NJ/2RK
2-71
(7) USB keyboard (120V /220 to 240V model only)
USB keyboard installation requires the following parts:
Keyboard holder 10 (1709AN0UN0)1 pc
USB Keyboard1 pc
Bundled parts of Keyboard holder 10 (1709AN0UN0)
Upper keyboard mounting bracket 1 pc
Lower keyboard mounting bracket 1 pc
Upper keyboard cover 1 pc
Lower keyboard cover 1 pc
Upper lid*
1
1 pc
Lower lid*
1
1 pc
Hook-and-loop fastener 2 pairs
Binding band 1 pc
Screws (M3x8 S-tite) 6 pcs
Screws (M3x8 S-tite Black)*
1
2 pcs
Screws (M3x8 P-tite)2 pcs
Screws (M4x8 S-tite) *
1
4 pcs
Screws (M4x14 S-tite)*
1
2 pcs
*1: Not used in this model.
Procedures
1. Turn the power switch off and disconnect the power plug.
2. Fix the upper keyboard mounting bracket(b) onto the lower keyboard mounting bracket(c) with the four screws
(a)(M3x8).
*: Match at the mark C position and then attach.
Figure 2-136
a
a
a
a
b
c
P
P
C