2NJ/2RK
2-16
7. Remove a screw(a) and slide the lever right
wards.
8. Fix the lever(b) using the screw(a) previously
removed at the right screw hole and unlock the
developer waste exit.
*: When the device is shipped again or removed, use
the reverse procedure to lock in the developer
waste exit. Failure to observe this caution could
result in deteriorated print quality and/or C call
(C7460).
9. Close the front middle cover and fix the cover
using the two screws.
10. Close the waste toner box cover.
11. Close the paper conveying unit.
Figure 2-22
(8) Affixing the operation panel sheet (220 to 240V models only)
Affix the operation panel sheet (a) in the applicable language by aligning it to the positioning boss (c) on the operation
panel (b).
Figure 2-23
1
2
3
a
b
c
To Next Page
Loading...
