2NJ/2RK
2-64
(6) IC card reader
IC card reader installation requires the following parts.
IC card reader 1 pc
Procedures
1. Turn the power switch off and disconnect the power plug.
2. Pull up the operation unit (a).
3. When the operation unit attaches to the left side, put the right
aside.
4. Remove one screw (b) (M3x8) and then remove the rear operation unit cover(c) in the direction of the arrow.
Figure 2-119
5. Open the document processor.
6. Remove two screws (a)(M4x8) and then detach the ISU right cover (b) in the direction of the arrow.
Figure 2-120
c
b
a
a
b
a
To Next Page
Loading...
