Kyocera TASKalfa 8002i

2WA/2NJ/2RK
7-52
(4-5) Original center and copy image center are mismatched
(4-6) Paper creases
Step Check description Assumed cause Measures Reference
1 Checking the paper width
guides, paper size guides
or the MP paper width
guides
The locations of the paper
width guides, paper size
guide A/B or the MP paper
width guides do not fit with
the paper size.
Relocate the paper width
guides, paper size guide A/B
or the MP paper width guides
to fit them with the paper
size.
2 Executing U034 The center line when
image writing the data is
incorrect.
Adjust the center line at U034
[LSU Out Left].
Executing
U034
Step Check description Assumed cause Measures Reference
1 Checking the paper width
guides, paper size guides
or the MP paper width
guides
The locations of the paper
width guides, paper size
guide A/B or the MP paper
width guides do not fit with
the paper size.
Relocate the paper width
guides, paper size guide A/B
or the MP paper width guides
to fit them with the paper
size.
2 Checking the paper The paper curls or is wavy. Replace the paper.
3 Checking the paper stor-
age place
Paper is stored in the high
humidity environment.
[Cassette heater standard
model]
Installing
the cas-
sette
heater
4 Checking the pressure
spring
The pressure springs are
not attached properly at
both ends of the registra-
tion roller, so the pressure
balance is uneven.
Reattach the springs at both
ends of the left and right reg-
istration rollers.
5 Checking the fuser unit The pressure springs at
the machine front and rear
ends of the fuser unit are
not properly attached.
Check the pressure balance
of both ends of the fuser unit
by checking the nipped pres-
sure on the solid image. If the
balance is uneven, replace
the fuser unit.
Detaching
and Reat-
taching the
fuser unit