Kyocera TASKalfa 8002i

2NJ/2RK
2-89
(8-2) In case installing the document table
Handset installation requires the following parts:
Handset (1909AG9JP0) 1 pc
Document table DT-5100 (1902LC0UN2) 1 pc
Bundled parts of handset (1909AC9JP0)
Handset 1 pc
Handset holder 1 pc
Handset mounting plate*1 1 pc
Protection cover*1 1 pc
Pin 2 pcs
Telephone wire 1 pc
Modular cord 1 pc
Nut M4 2 pcs
Bundled parts of Document table DT-730(B) (1902LC0UN2_)
Tray stay 1 pc
Tray mounting plate 1 pc
Tray cover 1 pc
Tray lower cover 1 pc
Tray fixing plate 1 pc
Sheet*
2
2 pcs
Pin 2 pcs
Nut M4 2 pcs
Screw (M4x8 screw with the binding head) 7 pcs
Screw (M4x14 screw with the binding head) 2 pcs
*: *1: This model is not used.
*2: One sheet is not used.
Procedures
1. Turn the power switch off and disconnect the power plug.
2. Pull up the operation unit (a).
3. Remove one screw (b) (M3x8) and then remove the rear operation unit cover(c) in the direction of the arrow.
Figure 2-170
c
b
a