2NJ/2RK-1
2-99
(9) Cassette heater
(9-1) In the case of main unit cassette (120V/220 to 240V models only)
Cassette heater installed model as standard
The cassette heater is not connected at factory but connect it
according to the procedures below.
Figure 2-192
Cassette heater connection (100V model only)
*:
1. Slide the controller cover (a) in the direction of the arrow and detach it.
Figure 2-193
2. Remove one screw (a)(M3x8) And then remove the left rear cover (b) by sliding in the direction of the arrow.
Figure 2-194
a
b
a
To Next Page
Loading...
