Kyocera TASKalfa 8002i

2NJ/2RK
2-46
(19)Cassette heater control setting (100V model only)
*: The model which the cassette heater is normally equipped and connecting to the connector in the cassette heater
connecting procedure.
*: If the setting is not executed, the cassette heater is not turned on. (Default setting is OFF)
1. Input "327" using the numeric keyboard and press the [Start] key.
2. Select [Mode 1] or [Mode 2]
3. Press the [Start] key and then set.
4. Press the [Stop] key.
*: When reflecting the setting, skip the maintenance mode, operate the shut-down from the normal screen and turn
the power switch ON/OFF.
(20)Exiting from the maintenance mode
1. Input "001" using the numeric keypad and press the [Start] key.
*: The maintenance mode is exited.
(21)Completion of installing the main unit (Turning the power off)
1. Turn the power switch off.
Figure 2-82
2. The confirmation screen of shut down is displayed. Select [Yes] in the confirmation screen.
*: It takes about 3 minutes to switch the power off.
(22)Turn the power on again
1. Turn the power switch on.
*: Check the main power switch (a) is ON when the power is not turned on.
Figure 2-83
IMPORTANT
After turning off the power switch, do not turn on the power switch again immediately. Wait 5 seconds or more, and
then turn on the power switch.
a