2NJ/2RK
2-8
(3) Change to the operation unit position
*: The operation unit position can be set to right side or left side of the machine. When shipping, it is set at the left
side.
When setting the operation unit position to the right side of the machine.
1. Pull up the operation unit (a).
2. Remove one screw (b) (M3x8) and then remove the rear operation unit cover(c) in the direction of the arrow.
Figure 2-8
3. Remove two pins (a) (M3x8) and then slide the operation unit(b) in the direction of the arrow.
Figure 2-9
c
b
a
a
b
a
To Next Page
Loading...
