Kyocera TASKalfa 8002i

2WA/2NJ/2RK
7-43
(3-14) Part of the image is not copied
Step Check description Assumed cause Measures Reference
1 Checking the settings Marked part by highlighter
pen on the original cannot
be scanned.
Set [Highlight] to [On] at
[System Menu/Counter] >
[Common Settings] > [Func-
tion Defaults] > [Original
Image]
2 Checking the original The original is not set
properly.
Reset the originals.
3 Checking the settings The original size and the
paper side do not match
on the operation panel.
(The setting is incorrect.)
Set the original size manu-
ally.
4 Checking the settings The copy position is
rotated automatically.
Set [Auto Image Rotation] to
[Off] from the System Menu.
5 Checking the settings The Border Erase function
is not properly set. (Setting
is too large.)
Lower the setting of the Bor-
der Erase.
6 Checking the contact glass The original scanning side
of the contact glass is dirty.
Clean the original scanning
side of the contact glass.
7 Checking the shading
plate
The shading plate is dirty. Clean the shading plate at
the backside of the contact
glass.
8 Checking the contact glass The contact glass is not
properly attached.
Reattach the contact glass.
9 Checking the FFC The FFC is not properly
connected, or it is faulty.
Reconnect the following FFC.
When the FFC terminals are
peeled off or deformed or the
FFC is broken, replace the
FFC. • CCD PWB - Engine
PWB
Wiring dia-
gram
10 Checking the ISU The ISU is attached
improperly.
Reattach the ISU. Detaching
and Reat-
taching the
ISU
11 Checking the original size
sensor
The original size and the
paper side do not match
on the operation panel.
(The original size sensor
misdetects.)
Replace the original size sen-
sor.
12 Checking the ISU The CCD PWB is faulty. Replace the ISU. Detaching
and Reat-
taching the
ISU