Kyocera TASKalfa 8002i - Page 114

2NJ/2RK
2-65
7. Remove two pins (a) (M4x6) and then remove the glass front cover (b) by sliding in the direction of the arrow.
Figure 2-121
8. Remove the ISU front cover (b) in the direction of the arrow.
Figure 2-122
9. Remove one screw (a) (M3x8) and then remove the rear operation unit cover B (b) by sliding in the direction of the
arrow.
Figure 2-123
a
b
a
b
a
b