Kyocera TASKalfa 8002i

2WA/2NJ/2RK
3-26
1. Toner fan motor 1.................................. Collecting scattered toner.
2. Toner fan motor 2.................................. Collecting scattered toner.
3. Developer fan motor ............................. Cooling the developer.
4. Drum fan motor ..................................... Cooling the drum section.
5. Exhaust fan motor 1.............................. Cooling the machine inside.
6. Exhaust fan motor 2.............................. Cooling the container.
7. Exhaust fan motor 3.............................. Cooling the developer.
8. LSU fan motor....................................... Cooling the laser scanner unit.
9. IH core fan motor .................................. Cooling the fuser section (front side).
10. Rear fuser fan motor ............................. Cooling the fuser section (rear side).
11. Front eject fan motor............................. Cooling the feedshift/reverse section (front side).
12. Rear eject fan motor ............................. Cooling the feedshift/reverse section (rear side).
13. Right front eject fan motor 1.................. Cooling the feedshift/reverse section.
14. Right rear eject fan motor 1 .................. Cooling the feedshift/reverse section.
15. Right front eject fan motor 2.................. Cooling the fuser section.
16. Right rear eject fan motor 2 .................. Cooling the fuser section.
17. IH fan motor .......................................... Cooling the IH PWB.
18. Duplex fan motor................................... Cooling the duplex section.
19. Power source fan motor........................ Cooling the power source section.
20. Controller fan motor .............................. Cooling the controller section.
21. Bridge fan motor ................................... Cooling the bridge section.
22. Front fuser edge fan motor ................... Cools the fuser edge section.
23. Rear fuser edge fan motor .................... Cools the fuser edge section.