Kyocera TASKalfa 8002i

2WA/2NJ/2RK
4-65
7. Remove the stop ring A (a) and then
remove the one way clutch (b) and PF
paper feed pulley (left) (c).
8. Remove the stop ring B (d) and then
remove the PF forwarding pulley (left)
(e).
Figure 4-88
9. Remove the stop ring (a).
10. While pressing the retard release lever
(b), remove the PF separation pulley
(left) (c).
11. Clean or replace the PF forwarding pul-
ley (left), PF paper feed pulley (left) and
PF separation pulley (left).
12. Reattach the PF forwarding pulley (left),
PF paper feed pulley (left) and PF sepa-
ration pulley (left) in the original position
of the primary paper feed unit.
13. When replacing the PF forwarding pul-
ley (left), PF paper feed pulley (left) and
PF separation pulley (left), execute
U903 (Jam counter clear).
Figure 4-89
b
a
c
d
e
14j0096
b
a
c
d
14j0097