2WA/2NJ/2RK
4-157
17. Remove one wire holder (a).
18. Release one wire saddle (b).
19. Disconnect two connectors (d) from the
IH PWB (c) according to the following
notes.
*: Confirm the power plug is removed
from the outlet when you remove the
connector, because a high current is
supplied to the IH unit by this connector.
*: Confirm the connected connector was
surely locked when you connect this
connector again.
Figure 4-234
b
a
c
d
c
14j0306
To Next Page
Loading...
