2 6-44,6-45 Added: U051 Initial setting 90ppm
6-48 to 6-50 Added: U053 Initial setting 90ppm
6-56 to 6-59,6-
61,6-63
Deletion: Initial setting 70 ppm/ 80ppm
6-74 Added: U100 Initial setting 90ppm
6-76 to 6-80 Added: U106 Initial setting 90ppm
6-87 Added: U131 Initial setting 90ppm
6-96 Added: U147 Initial setting 90ppm
6-103 Added: U161 Initial setting 90ppm
6-125 Correction: U230 PF1→PF2, PF2→PF3
6-126 Correction: U237 Procedure
6-146 Correction: U250 Cassette1 to 7 Initial setting
6-166,6-167 Correction: U403, U404 left margin, right margin
6-190,6-191 Correction: U464 Initial setting: Leaving Time, Driving
Time
6-202 Correction: U600 Destination code (Country Code
default) list
8-50,8-51 Correction: YC24 Pin 1 to 38 →A1 to A19, B1 to B19
9-3 Correction: N5 10→60
9-4 Added: R0 (When DF-7110 is installed)
9-5 Added: R4 Cassette 5 to 7
9-21 Correction: (7) Feed PWB (3)
9-26 Correction: (12) CCD - Engine PWB
3 15 June 2018 Deletion; Firmware update
4 20 August 2019 3-27 Correction: Power source fan motor (302HN4401_ >
302K09430_)
5 8 December 2021 7-97 to 7-98
7-302 to 7-318
Added: Add JAM code (J7910 to J-7935)
Revision Date Pages Revised contents
To Next Page
Loading...
