Kyocera TASKalfa 8002i - Page 514

2WA/2NJ/2RK
4-186
6. Remove eight screws (a)(M3x8).
7. Release two lower hooks (b) and
remove the rear lower cover (c).
Figure 4-273
8. Disconnect all the connectors and tab
from the power source PWB.
9. Remove five screws (a)(M3x8).
10. Release two board supports (b) and
remove the power source PWB (c).
11. Check or replace the power source
PWB (c) and then reattach the parts in
the original position.
Figure 4-274
b
a
a
a
c
14j0205
a
a
a
c
a
a
a
a
14j0418