2WA/2NJ/2RK
4-212
5. Disconnect two connectors (b) from the
DPSHD PWB (a).
Figure 4-322
6. Remove the CIS unit (a) while pushing
the two hooks (c) of the front and rear
glass holder (b) in the direction of the
arrow to unlatch them.
7. Detach the CIS glass (d) or CIS (e) from
CIS assembly (a).
IMPORTANT
Check the position of black marking (f) for dis-
tinction of the surface / back side of the glass.
Also, make sure not to touch the glass surface.
If it is dirty, wipe it off with a dry cloth.
*: Take care of the front and rear side when
attaching the CIS glass.
Take care of the marking in the figure.
Paper dust easily adheres if mistaken and
it is affected when scanning originals.
Figure 4-323
a
b
b
14j0508
1
22
b
cc
b
b
f
d
e
a
14
0509
To Next Page
Loading...
