Kyocera TASKalfa 8002i - Page 666

2WA/2NJ/2RK
6-73
Setting: Set DC Bias
1.Displays the current setting.
Setting: Adj DC Bias
1.Select the item to set.
2.Change the setting value by using [+] [-] key or the numeric keypad.
* :When the setting value is increased, the image get thinner, and it gets thicker when the set-
ting value is decreased.
3.Press the [Start] key to set the setting value.
Setting: Set Low Temp
1.Change the setting value by using [+] [-] key or the numeric keypad.
2.Press the [Start] key to set the setting value.
Items Contents
DC1 Bias(K) Black main charge DC bias correction value (Full speed)
DC1 Bias Half(K) Black main charge DC bias correction value (Half speed)
Items Contents Setting range Data
variation
Initial
setting
DC2 Bias(K) Black main charge DC bias additional
value (Full speed)
-128 to 127 1V 0
DC2 Bias
Half(K)
Black main charge DC bias additional
value (Half speed)
-128 to 127 1V 0
Items Contents Setting range Data
variation
Initial
setting
Set Low
Temp
Set the pre-charge time at power ON. 0 to 6 - 1