2WA/2NJ/2RK
6-171
Error codes
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
Codes Occurrence
position
Contents Re-
adjust-
ment
S001 Scanner Original Refer ence patch is not detected Enable
S002 Original deviation is in excess in the main scan-
ning direction
Enable
S003 Original deviation is in excess in the sub-scan-
ning direction
Enable
S004 Original skew is in excess Enable
S005 Original type error Enable
SFFF Other scanner error Disable
E001 Engine Engine status error Disable
E002 Adjustment result error Disable
EFFF Other engine error Disable
C001 Controller Pause status Disable
C002 Adjustment result error Disable
C110 Adjustment value (increase amount) value error
(black)
Disable
C120 Adjustment value (increase amount) value error
(cyan)
Disable
C140 Adjustment value (increase amount) value error
(magenta)
Disable
C180 Adjustment value (increase amount) value error
(yellow)
Disable
C210 Adjustment value (increase rate) error (black) Disable
C220 Adjustment value (increase rate) value error
(cyan)
Disable
C240 Adjustment value (increase rate) value error
(magenta)
Disable
C280 Adjustment value (increase rate) value error (yel-
low)
Disable
CFFF Other controller error Disable
To Next Page
Loading...
