2WA/2NJ/2RK
6-201
Contents
Initializes software switches, and all data and image memory in the backup data on the FAX
PWB according to the destination and OEM setting.
Initializes the file system and then initializes the communication record and the registered con-
tents if the file system is checked and an error is detected there.
Purpose
Initialize the FAX PWB
Method
1.Press the [Start] key.
2.Select the [Execute].
* :The screen for entering the destination code and OEM code is displayed.
3.Select [Country Code] and enter a destination code using the numeric keys.
* :Refer to the following destination code list.
* :No need to change the default value of [OEM Code].
4.Press the [Start] key to set the setting value.
* :Data initialization starts.
Press the [Stop] key to cancel the data initialization.
5.The firmware version is displayed after the data initialization.
The firmware version of 3 types of application, boot and IPL is displayed.
* :When initialization is successful, "Completed" is displayed for one second.
* :Where an irregular value is input, when it initializes, the following errors are displayed.
U600 Initialize: All Data
(Message: Initialize: All Data)
Items Contents
Execute Executing data initialization
Items Contents
Country Code Setting Destination code
OEM Code Sets the OEM code
Kind of error
Unknown Country (When Country Code is unknown)
Unknown OEM (When OEM Code is unknown)
Unknown Country (When both are unknown)
To Next Page
Loading...
