2WA/2NJ/2RK
6-207
2.Press the [Start] key to set the setting value.
Setting: Cut Line: Auto
Set the maximum number of lines to be ignored if the received data volume exceeds the record-
ing capacity when the data is recorded in the auto reduction mode onto A4R or Letter R paper.
If the number of excess lines is below the setting, those lines are ignored. If over the setting, the
entire data on a page is further reduced so that it can be recorded on the same page.
1.By using the [+] [-] keys or the numeric keys, change the setting value.
* :Increase the setting value if a page received in the reduction mode is reduced too much with
the trailing edge margin. Decrease the value if there is dropout in received image.
2.Press the [Start] key to set the setting value.
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
Contents Setting
range
Data
varia-
tion
Initial
setting
Number of lines to be ignored when receiving in the A4R
auto reduction mode.
0 to 22 - 0
To Next Page
Loading...
