LG-Ericsson ipldk-60 - Page 301

ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
26
PGM
111
Flex
Btn
Description Default Values
1: Flash Drop, the active call is dropped
2: Flash ignore, the flash is ignored, no action is taken
3: Hold Release, the active call is placed on hold and the user receives dial
tone, the held call is disconnected if the user hangs up
Loop LCR
Account Code
16 If this value is set to On, the station user must enter an Account Code to use Loop
LCR.
0 (Off) 0 = Off
1 = On
VMIB Message
Type
17 This parameter determines the order of Voice Mail message playback.
0 = LIFO, Last-in, First-out
1 = FIFO, First-in, First-out
1 (FIFO) 0 = LIFO
1 = FIFO
Off-Net Call
Forward
18 When enabled (On), the station is permitted to activate Off-Net Call Forward. The
user can forward calls over a CO line. See PGM 112, Flexible button 12 to define
the type of calls that will forward.
1 (Disable) 0 = Enable
1 = Disable
Forced Hands
Free
19 When enabled (On), the station can change the Intercom Signal mode of the called
station from Tone to Handsfree.
1 (On) 0 = Off
1 = On
Reserved 20
Reserved 21
Caller Voice Over 22 When this parameter is On, the station can place calls to other stations using Voice
Over. The receiving station must be enabled to receive Voice Over, PGM 113
Flexible button 6.
0 (Off) 0 = Off
1 = On
SIP User ID
Table Index
23 This parameter determines the caller id for a station when employing SIP for a call.
When using SIP, the caller id is based on the CLIP/COLP (PGM 143 Flexible button
1 and 2) or the User ID defined from the SIP User ID Table index (PGM 501) entered
here.
00 00-16
Redial DTMF 24 When enabled (On), the station receives DTMF tones during Redial. 1 (On) 0 = Off
1 = On