ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
28
PGM
112
Flex
Btn
Description Default Values
Priority Line
Answer (PLA)
7 When enabled (On), lifting the handset or pressing the ‘On/Off’ button answers an
incoming call. Calls are answered in the priority defined in PGM 173.
1 (Enable) 0 = Disable
1 = Enable
Prepaid Call 8 When enabled (On), the station will be subject to the Prepaid Call feature. If the
station exhausts the prepaid allocation, the station will be unable to place calls on a
CO line. If the allocated funds are exhausted during a call, warning tone is provided
and the call is terminated after the CO Call Drop timer (PGM 180, Flexible button 16.
0 (Off) 0 = Off
1 = On
Speed Dial
Access
9 When enabled, the station can place calls employing System Speed Dial numbers. 1 (Enable) 0 = Disable
1 = Enable
Two-way Record 10 When enabled (On,) the station user can record conversations on incoming or
outgoing calls.
0 (Off) 0 = Off
1 = On
Fax Mode 11 When enabled (On), CO line calls to an SLT port will ring the port once to notify a
FAX machine of an incoming call. In addition, calls to the port are not subject to
recall and tones such as Camp-on are not sent to the port.
0 (Off) 0 = Off
1 = On
Off-net Call
Mode
12 When allowed Off Net Forward (PGM 111, Flexible button 18), this parameter
determines the type of calls, (External CO line calls or All for both external CO line
and Intercom calls) the station user can forward Off Net.
1 (Ext) 0 = All (ICM & CO)
1 = External CO line
UCD Group
Service
13 When enabled (On), if the station is a member of a UCD group and is busy, DISA
and DID calls will route to the group and follow the assigned group attributes.
0 (Off) 0 = Off
1 = On
Ring Group
Service
14 When enabled (On), if the station is a member of a Ring group and is busy, DISA
and DID calls will route to the group and follow the assigned group attributes.
0 (Off) 0 = Off
1 = On
Stop Camp-on
Tone
15 If this parameter is enabled, Camp-on Tone to the station is disabled. 0 (Disable) 0 = Disable
1 = Enable
Line Length 16 This parameter distinguishes the line length when the distance between the station
and the system varies significantly. Intended for SAF only
1 (Long) 0 = Short
1 = Long
2 = Far
To Next Page
Loading...
