ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
55
PGM
129
Flex
Btn
Description Default Values
VMIB Message
Password
6 The Voice Mailbox may require entry of a valid system password for access to the
mailbox.
0 (Off) 0 = Off
1 = On
VMIB Message
Time
7 If this parameter is set to ‘On’, the VMIB will play the Date and Time stamp for each
message before playing the message.
0 (Off) 0 = Off
1 = On
VMIB Message
Type
8 This parameter defines the order in which messages are retrieved from the Voice
Mailbox, LIFO (Last-In First-out) or FIFO (First-in First-out).
0 (LIFO) 0 = LIFO
1 = FIFO
VMON 9 The system can be configured notify the user of new messages over an outbound
telephone call.
0 (Disable) 0 = Disable
1 = Enable
VMON CO Grp 10 When Outbound Notification is enabled, the CO Line group to use to place the
outbound notification call can be configured.
01 01 ~ 24
VMon Telephone
Number
11 When Outbound Notification is enabled, the telephone number to call must be
assigned.
24 digits
VMON Retry
Count
12 Should the notification fail, error, busy, or no-answer, the system will retry the
outbound call up to 9 times. After the number of attempts, the system abandons the
notification.
2 1 ~ 9
VMON Retry
Interval
13 Should the notification fail, the system will attempt the call again after the “VMON
Retry Interval” time.
10 seconds 01 ~ 60 seconds
Cascade
Destination
14 The system can send a copy of a received voice mail to another Voice mailbox.
Flexible button 1 = Station
Flexible Button 2 = Voice Mailbox number
Button 1 – Station
Number
Button 2 – Voice
Mailbox Number
Cascade Type 15 The system will send a copy of a new message under one of several conditions as
assigned here.
0 (No cascade) 0 – No Cascade
1 – Immediate
2 - Notify Failure
3 - Urgent
To Next Page
Loading...
