ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
86
PGM
161
Flex
Btn
Description Default Values
buttons 13 and 14.
No DSS
Indication
18 When enable (On), the CO line and DSS/BLF buttons at a Station do not provide
incoming call indications for the calls to other Stations.
0 (Disable) 0 = Disable
1 = Enable
UK Billing Mode
UK Only
19 If this parameter is ‘On’, the UK Billing Mode is applied. (UK Only) 0 (Off) 0 = Off
1 = On
COS 7 When
Authorization Fail
20 When enabled (On), if an invalid Authorization Code is entered, the system changes
the Station COS to 7 – fully restricted. Also, if the station has no Day and Night COS
assignment (PGM 116) the Day and Night are changed to 7 and must be reassigned
to recover. Otherwise, the user may return to the normal COS with the COS Restore
procedure.
0 (Off) 0 = Off
1 = On
5-digit
Authorization
Code
21 This parameter determines the structure of Authorization Codes; when ‘On’ fixed 5-
digit Authorization Codes are used, when Off variable 3 to 11-digit codes are used
and ‘#’ is the terminating digit.
0 (Off) 0 = Off
1 = On
LCR Dial Tone
Detect
22 When enabled (On), for all LCR Modes except M13, the system will verify dial tone
on an analog CO line; if dial tone is not received, the Alternate DMT Index is used to
route the call.
0 (Off) 0 = Off
1 = On
Transit-Out
Security
23 When enabled (On), the system will verify the IP address in the Transit-Out set-up
message received by the VOIB is from a registered IP address. If not registered, the
Transit-Out call will fail.
0 (Off) 0 = Off
1 = On
To Next Page
Loading...
