ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
118
PGM
180
Flex
Btn
Description Default Values
drops. Also, see Flexible button 22.
Reserved 17
CO Dial Delay
Timer
18 This parameter defines a delay before dialed digits are sent by the system over
analog CO/PBX lines. Due to slow response of certain PSTN and PABX circuits, it is
possible to begin dialing before the circuit is ready to accept and register digits. In
order to minimize restricted dialing and misdialing, any digits dialed prior to the timer
expiration are buffered and sent when the delay timer expires.
01 (100 milli-
seconds)
00 ~ 99 in 100 mill-
second increments
CO Release
Guard Timer
19 This parameter determines the duration a CO line will remain unavailable after
disconnect to allow the network to ‘clear-down’ the call.
020 (2 seconds) 001 ~ 150 in 100 mill-
second increments
CO Ring Off
Timer
20 This parameter sets the maximum Ring-off signal before the call is considered
abandoned. The ipLDK considers shorter periods a continuation of the alerting cycle
for the incoming call.
060 (6 seconds) 010 ~ 150 in 100 mill-
second increments
CO Ring On
Timer
21 This parameter sets the minimum Ring-on signal duration the system will detect as
an incoming CO call. The ipLDK considers shorter periods a spurious signal.
2 (200 milli-
seconds)
1 ~ 9 in 100 milli-
second increments
CO Warning
Tone Timer
22 This parameter sets the amount of time before receiving a warning tone as a
reminder of the elapsed call time on an outgoing CO line conversation. (Intended for
Korea only)
180 seconds 060 ~ 900 in 1
second increments
Reserved 23
2
nd
Call Alert
Timer
24 When a busy SLT receives a 2
nd
call, the station receives a call waiting tone a
intervals of the 2
nd
Call Alert timer.
To Next Page
Loading...
