LG-Ericsson ipldk-60 - Page 395

ipLDK-60 Issue 2.0
Admin Programming Manual July, 2010
120
PGM
181
Flex
Btn
Description Default Values
ICM Dial Tone
Timer
7 This parameter sets the duration Intercom dial tone is provided to the user. When
the timer expires, the call is abandoned and the system returns error tone.
10 seconds 01 ~ 20 In 1 second
increments
Inter-digit Timer 8 This parameter sets the duration the system permits the user between dialed digits
on an internal call. When the timer expires, the call is abandoned and the system
returns error tone.
05 seconds 01 ~ 20 in 1 second
increments
MSG Wait
Reminder Tone
Timer
9 This parameter sets the duration between Msg Wait reminder alerts; a ‘00’ setting
disables the reminder tone.
00 (disabled) 00 ~ 60 in 1 minute
increments
Paging Timeout
Timer
10 This parameter sets the duration of a Page. When the time expires, the Page
disconnects and returns the Internal/External Page Zone to idle. A setting of ‘000’
disables the timer.
015 seconds 000 ~ 255 in 1
second increments
Pause Timer 11 This parameter sets the time the ipLDK waits before sending digits on a CO line
when a Pause is encounter in a Speed Dial number. The Pause Time is also used
for LNR and other automatic dialing.
3 seconds 1 ~ 9 in 1 second
increments
Preset Call
Forward Timer
12 This parameter sets the duration CO Line calls signal the assigned station before
reroute to the Preset Forward destination (see PGM 121).
25 seconds 00 ~ 99 in 1 second
increments
SLT DTMF
Release Timer
13 This parameter sets the duration that a DTMF receiver is connected to the SLT port.
When set to 0, the DTMF receiver will release if no digits are dialed for the inter-digit
time, button 8, remains connected for the duration of the call.
00 (disabled) 00 ~ 60 in 1 second
increments
3 SOFT Auto
Release Timer
14 This parameter determines the duration a Softkey menu is displayed before returning
to the idle menu.
05 seconds 01 ~ 30 in 1 second
increments
VM Pause Timer 15 This parameter sets the duration of a Pause when required for an external Voice
Mail.
30 (3 seconds) 01 ~90 in 100 milli-
second increments
Transit Connect
Timer
16 This parameter defines the time delay when a networked system returns a connect
message to a system requesting use of an analog pulse dial CO line to allow the CO
04 seconds 01 ~ 30 in 1 second
increments