SERVICE PROCEDURES REQUIRING MINOR DISASSEMBLY SERVICE MANUAL NUMBER 28
Page 4A-14 90-863160 MAY 2000
4. Apply Loctite 271 to bell housing threads and install hinge pins. Torque hinge pins to
150 lb-ft (203 Nm).
76619
a
b
c
a-Bell Housing
b-Gimbal Ring
c-Hinge Pin Tool (P/N 91-78310)
5. Install trim position sender as follows:
a. Place sterndrive unit in the full DOWN/IN position.
b. Turn center rotor of trim limit switch to align index mark with index mark on sender
body.
71218
a
a-Index Marks
c. Install trim position sender and secure with attaching hardware.
71220
a
a-Attaching Hardware
To Next Page
Loading...
