Navistar INTERNATIONAL DT 466 Service Manual

164 FRONT COVER AND RELAT ED COMPONENTS
Removal
GOVERNMENT REGULAT ION: Engine
fluids (oil, fuel, and coolant) may be a hazard
to human health and the environment.
Handle all fluids and other contaminated
materials (e.g. filters, rags) in accordance
with applicable regulations. Recycle
or dispose of engine fluids, filters, and
other contaminated m aterials according to
applicable regulations.
WARNING: To prevent personal injury or
death, read all safety instructions in the "Safe
ty
Information" section of this manual.
WARNING: To prevent personal injury or
death, shift transmission to park or neutral,
set
parking brake, and block w heels before doing
diagnostic or service procedures.
WARNING: To prevent personal injury or
death, make sure engine has cooled before
removing components.
WARNING: To prevent personal injury or
death, do not open pressurized Freon® lines.
WARNING: To prevent personal injury or
death, wear safety glasses with side shields.
Limit compressed air pressure to 207 kPa (30 psi).
WARNING: To prevent personal injury or
death, do not let engine fluids stay on your skin.
Clean skin and nails using hand cleaner and wash
with soap and w ater. Wash or discard clothing
and rags contaminated with engine fluids.
Alternator Bracket
Figure 212 Alternator bracket bolts
1. Bolt, M10 x 120 (2)
2. Alternator bracket
3. Bolt,M8x100(2)
1. Remove M8 bolt and harness routing guide.
2. Remove two hex flange bolts and nuts (M10 x
120).
3. Remove two hex flange bolts and nuts (M8 x 100).
4. Remove alternator bracket.
EGES-265-2
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.

Navistar INTERNATIONAL DT 466 Specifications

General

Brand	Navistar
Model	INTERNATIONAL DT 466
Category	Engine
Language	English