414 AIR COMPRESSOR, POWER STEERING PUMP, AND POWER
TAKE-OFF
Power Steering Pump without Air Compressor
NOTE: The following steps are only for applications
that are not equipped with an air compressor.
7
2
5
4
3
6
1
8
H16020
6
Figure 654 Power steering pump without air compressor
1. Plug assembly, M18 (standard
torque) (General Torque
Guidelines, page445)
2. Cap
3. Power steering pump assembly
4. Nut, M12 (2)
5. O-ring gasket
6. Bolt, M12 x 90 (2)
7. Power steering pump gear nut
and shaft key (supplied with
pump)
8. Drive gear (supplied with pump)
1. Apply a small amount of assembly grease to the
O-ring and install into groove on front cover.
2. Install two power steering pump mounting
bolts (M10 x 90) and nuts (M10) and tighten
to the standard torque value (General Torque
Guidelines, page445).
3. Install power steering low-pressure hose.
4. Install power steering high-pressure hose.
EGES-265-2
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
To Next Page
Loading...
Need help?
General