Navistar INTERNATIONAL DT 466 Service Manual

AIRCOMPRESSOR,POWERSTEERINGPUMP,ANDPOWER
TAKE-OFF
413
1. Apply a small amount of assembly grease to
the O-ring and install into groove on backside of
compressor.
2. Install two power steering pump mounting bolts
(M10 x 35) and tighten to the special torque value
(Table 57).
3. Install low-pressure hose.
4. Install high-pressure hose.
EGES-265-2
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.

Navistar INTERNATIONAL DT 466 Specifications

General

Brand	Navistar
Model	INTERNATIONAL DT 466
Category	Engine
Language	English