OIL SYSTEM MODULE A SSE MBLY A ND SECONDARY FILTRATION 299
Specifications
Table 41 Oil System Module and Secondary Filter Specifications
Cooler heat exchanger, DT 466
23 plates
Cooler heat exchanger, HT 570
33 plates
Cooler heat exchanger, all engines with front drive axle
33 plates
Oil pressure regulating valve, opening pressure 380 kPa (55 psi) @ 38° C (100° F)
Oil filter bypass valve, opening pressure 345 kPa (50 psi)
Oil thermal valve, opening temperature 111° C (232° F)
Special Torque
Table 42 Oil System Module and Secondary Filter Spec
ial Torques
Coolant drain plug, M18 24 N·m (18 lbf·ft)
Lube adapter bolts
29 N·m (21 lbf·ft)
Oil system module mounting bolts 26 N·m (19 lbf·ft)
Oil pressure regulator valve 68 N·m (50 lbf·ft)
Oil thermal valve assembly 29 N·m (21 lbf·ft)
Cooler heat exchanger mounting bolts, M8
29 N·m (21 lbf·ft)
Oil cooler drain tube bracket bolt 26 N·m (19 lbf·ft)
Oil supply tube fitting (turbocharger) 24 - 26 N·m (17 - 19 lbf·ft)
Plug assembly, M12
5 N·m (46 lbf·in)
Secondary filter mounting bolts 26 N·m (19 lbf·ft)
Secondary filter stud assembly 20 N·m (15 lbf·ft)
Special Service Tools
Table 43 Oil System Module
and Secondary Filter Special Tools
Air Pressure Regulator
Obtain locally
Oil Cooler Test Plate ZTSE4654
Oil Filter Wrench ZTSE1879
Slide Hammer Puller Se
t
Obtain locally
EGES-265-2
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
To Next Page
Loading...
Need help?
General