CRANKCASE, CRANKSHAFT, AND CAMSHAFT 273
1
2
3
4
5
6
7
89
10
11
12
13
14
H06084
8
4
1
5
9
7
3
2
6
10
Figure 400 Recommended crankcase ladder torque sequence
Figure 401 Torquing the crankcase ladder bolts
4. Using the recommended crankcase ladder torque
sequence, tighten the inboard bolts (M12 x 35) to
thespecialtorquevalue(Table39).
5. Using the recommended crankcase ladder torque
sequence, tighten the outboard bolts (M10 x 25)
to the special torque value (Table 39). These bolts
are indicated by the circled numbers in the above
illustration.
EGES-265-2
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
To Next Page
Loading...
