344 FUEL SYSTEM
Figure 533 Removing the fuel filter outlet gasket
5. Discard the fuel filter outlet gasket between fuel
filter assembly and intake manifold.
Figure 534 Removing the fuel rail plug assembly
(2)
6. Remove the plug assembly (M12) from each end
of the intake manifold and discard O-ring seal.
You may also need to remove the rear engine
lifting eye to gain access to remove the rear plug.
Figure 535 Removing the fuel valve assembly
(air bleed and pressure test port)
7. Remove the fuel valve assembly (air bleed and
pressure test port), located at the front end of the
intake manifold. Discard O-ring seal.
EGES-265-2
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
To Next Page
Loading...
Need help?
General