436 APPENDIX A – SPECIFICATIONS
Table 63 Front Cover, Vibration Damper, Gerotor Oil Pump, Front Engine Mount, and G
ear Train
Specifications (cont.)
570 high-mount, (spin-on) 465 (18.3) 201.2 (7.92)
1.3 : 1
466 mid-mount, (spin-on) 411 (16.2) 201.2 (7.92)
1.08 : 1
466 low-mount, (spin-on) 310 (12.2) 201.2 (7.92)
1.08 : 1
466 low-mount, Horton
DriveMaster)
310 (12.2) 201.2 (7.92)
1.08 : 1
570 low-mount, (spin-on) 310 (12.2) 201.2 (7.92)
1.3 : 1
570 low-mount, (Horton
DriveMaster)
310 (12.2) 201.2 (7.92)
1.3 : 1
466 low-mount, (bolt-on) 310 (12.2) 201.2 (7.92)
1.08 : 1
570 low-mount, (bolt-on) 310 (12.2) 201.2 (7.92)
1.3 : 1
NOTE: The high-mount and mid-mount fan drives s
hare the same part number, however the fan drive is
inverted depending upon application.
Table 64 Oil Fill Specifications
Dry engine (after rebuild and new filter) 34 L (36 quarts US)
Wet engine (after oil drain and filter change) 28 L (30 quarts US)
Table 65 Connecting Rod Specifications
Bend (max.) 0.06 mm (0.003 in)
Center-to-center distance between connecting rod bearing bore and
piston pin bushing bore
219.4 - 219.5 mm (8.638 - 8.642 in)
Connecting rod bearing bore inside diameter 85.130 - 85.156 mm (3.3516 -
3.3526 in)
Connecting rod bearing inside diam
eter (installed)
80.05 - 80.10 mm (3.1518 - 3.1536
in)
Connecting rod bearing bore out-of-round (max.) 0.02 mm (0.00078 in)
Connecting rod bearing bore taper (max.) 0.02 mm (0.00078 in)
Connecting rod bearing runni
ng clearance
0.030 - 0.107 mm (0.0012 - 0.00
42
in)
Connecting rod side clearance on crankshaft 0.13 - 0.48 mm (0.005 - 0.019 in)
Piston pin bushing inside
diameter
46.393 - 46.401 mm (1.8265 -
1.8268 in)
Twist (max.) 0.05 mm (0.002 in)
Table 66 P iston Specifications
466 piston configuration
Piston material Aluminum alloy
EGES-265-2
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
To Next Page
Loading...
