– 112 –
CHAPTER 2 Operations of SV8500 Server
9. TRAFFIC MANAGEMENT
To obtain the value of common equipment usage, the system provides traffic measurement feature. It can
improve the system efficiency.
9.1 Kind of Traffic Measurement
9.1.1 Description of Traffic Measurement
The kinds of traffic measurements are shown below.
Table 2-1 Traffic Measurement Types
TYPE
KIND OF
MEASUREMENT
DESCRIPTION
1
Note 1
Terminal Traffic
Measurement
Note 2
Measurement of traffic on a per LENS basis, and measurement of the total
traffic on a PIR basis.
2
Note 1
Route Traffic
Measurement
Measurement of traffic on a per route basis.
3
Note 1
Note 6
Station Peg Count Measurement of the number of outgoing connections, intra-office calls,
outgoing C.O. line calls, TIE line calls, etc. originated by each station.
4
Note 1
Note 6
Note 6
ATTCON Peg Count Measurement of the number of each type of call handled at the ATTCON/
DESKCON.
5
Note 1
Route Peg Count Measurement of the number of various types of call connections on a per
route basis.
6
Note 6
Service Peg Count
Measurement of the number of times the following services are operated:
Call Hold Speed Calling - System
Call Back Speed Calling - Station
Executive Right of Way Off-Hook Outgoing Trunk Queuing
Call Waiting Outgoing Trunk Queuing
Call Pickup - Group Consultation Hold - All Call
Call Pickup - Direct Call Transfer - All Calls
Call Forwarding - All Calls Three-Way Calling
Call Forwarding - Busy Line
Call Forwarding - Don’t Answer
8 UCD Route Peg Count Measurement of the number of incoming calls, answered calls, and
abandoned calls handled at UCD Groups on a per route basis.
9 UCD Group Peg
Count
Measurement of the number of incoming calls, answered calls and
abandoned calls on a UCD Group basis.
10 UCD Station Peg
Count
Measurement of the number of incoming calls, answered calls and
abandoned calls for each station on a UCD Group basis.
15
Note 3
Note 6
ATT Answer Peg
Count
Measurement of the number of answered calls handled by each attendant.
18 Connection Route Peg
Count
Measurement of the number of various type of call connection on a
connection route basis.
19 Connection Route
Traffic
Measurement of traffic on a connection route basis.
20 IP Service Peg Count The total number of call origination/termination via FCCS Networking via
IP and CCIS Networking via IP, on a Node-to-Node basis.
Note 3
21 IP Service Traffic
Measurement
Measurement of IP service-related traffic on a Node-to-Node basis (IP
service: FCCS Networking via IP, CCIS Networking via IP).
Note 3
To Next Page
Loading...
