NEC UNIVERGE SV8500 - Initialization by INIT Key Operation (EMA Card)

– 51 –
CHAPTER 2 Operations of SV8500 Server
3.4 Initialization by INIT key Operation (EMA card)
The following initialization type is available.
• Non Load Initial
All on-going calls will be disconnected. The system will be rebooted by using program and office data that
are in the MEM.
STEP 1 Identify which system of CPU is in operation. The following shows an example when the system
is operating by CPU #0.
STEP 2 Press “INIT” key on the EMA card to start Non Load Initial.
STEP 3 Check the lamp indications on the EMA card.
STEP 4 Set the current date and time from the PCPro. (Refer to How to Adjust Date and Time.)
STEP 5 Release the indicated alarm. (Refer to How to Stop Alarm Indications.)
Lamp Layout on EMA Card (when CPU #0 is active) Lamp (Color) Status
PWR (Green) On
SYS ALM (Red) Off
LINK (Green) On
ACT (Green) On
ALM (Red) Off
Lamp (Color) Status
PWR (Green) On
LINK (Green) On
ACT (Green) On
SYS ALM (Red) On
[MEM]
- Program
- Office Data
Initialization
PWR
SYS
ALM
SYS 1
MB
(SUB)
SYS
LOCK
SYS
SEL
PFT
LINK ACT ALM
INIT
PBI No.
SYS 0
12 12
SW00
SW01
ON
0
1
PWR
SYS
ALM
SYS 1
MB
(SUB)
ON
0
1
SYS
LOCK
SYS
SEL
PFT
LINK ACT ALM
INIT
PBI No.
SYS 0
12 12
SW00
SW01
INIT key