– 824 –
CHAPTER 7 Maintenance Commands
DPSW: Display Package Switch Status
1. Functional Outline
This command is used to display the following information on a Line/Trunk or Control circuit card:
When PCPro is in On-line Mode (=connected to the system)
• Current status of each switch
• Explanation of each switch function
When PCPro is in Off-line Mode (= not connected to the system)
• Explanation of each switch function
Note 1: When using this command, make sure that each circuit card’s related database file have already been
installed to the PCPro. (See the FLINST command for more information.)
2. Parameters
Input Data
KIND: Display Kind (selection)
• (PCPro=) On-line Mode
• (PCPro=) Off-line Mode
TYPE: Circuit Card Type (selection)
• Line Trunk Package
• Control Package
PMN: Port Micro Processor Number
PKG NAME: Circuit Card Name
LP: Local Partition Number [00-06 (even number only)]
Note 2
SYSTEM: System Note 2
0=System 0
l=System 1
MG: Module Group Number [00-07]
Note 2
UNIT: Unit Number [0-3] Note 2
To Next Page
Loading...
