– 885 –
CHAPTER 7 Maintenance Commands
MBTC: Make-Busy of Trunk-Continuous
1. Functional Outline
This command is used to assign the IDLE/BUSY status of trunks. By using this command, multiple trunks can
be placed into IDLE/BUSY state simultaneously per a route designated in RT parameter.
2. Parameters
Input Data
RT: Route Number
TK: Trunk Number
Note Note:
MB: Make-Busy Information [0-2]
0=Make Idle
1=Make Busy (Outgoing)
2=Make Busy (Bothway)
Note: Multiple trunks can be assigned simultaneously per a route designated in RT parameter.
To Next Page
Loading...
