– 199 –
CHAPTER 3 System Messages
3. System Messages
This section explains how to read and analyze system messages displayed during routine diagnosis, system
operation status controlling, and occurrence of a fault within the system. The following table provides a list of
system messages.
System Messages List
MESSAGE NO. SYSTEM MESSAGE
0-C Reset Interrupt
0-D CPU Clock Down
0-E C-Level Infinite Loop
0-F Memory Failure
0-G B1-Level Infinite Loop (Permanent)
0-H B1-Level Infinite Loop (Temporary)
0-I Mate CPU Failure
0-J Abnormal Interrupt
1-A Both TSW Failure (Permanent)
1-B TSW Failure (Permanent)
1-C Both TSW Write Failure
1-D TSW Write Failure
1-E Both TSW Clock Failure
1-F TSW Clock Failure
1-O Both PLO Failure
1-P PLO Failure
1-S Module Group Down Failure
1-T TSW ACT Change Report
1-U DLKC Data Transfer Failure (Permanent) (4-IMG only)
1-V DLKC Data Transfer Failure (Temporary) (4-IMG only)
1-W PLO Restore
2-T AP-INT Data Transfer Failure (Permanent) Note 3
2-U AP-INT Data Transfer Failure (Temporary) Note 3
2-V IP Data Transfer Failure (Permanent) Note 3
2-W IP Data Transfer Failure (Temporary) Note 3
3-B C-Level Infinite Loop (Permanent)
3-C C-Level Infinite Loop (Temporary)
3-D Lock-Up Failure (Permanent)
3-E Lock-Up Failure (Temporary)
3-F -48V Over Current
To Next Page
Loading...
