– 826 –
CHAPTER 7 Maintenance Commands
DPTR: Display of Capacity / License
1. Functional Outline
This command is used to display the line capacity of the system and the license number of the Soft Phones.
Also license registration information such as the number of registered licenses and IP terminals is displayed for
each IP terminal type.
Note: In addition to System Capacity License and IP Line Capacity, the number of Soft Phone Licenses is re-
quired to be obtained.
2. Parameters
Read Type: CAPACITY
LICENSES
<When CAPACITY is selected>
Capacity Type:
System Capacity
Client License
Capacity [0-4294967295]
Capacity and number of Client License provided for the System will be indicated.
<When LICENSES is selected>
Device Type:
Hard Phone Type-A
Softphone Type-A
Standard SIP
Standard SIP Softphone
Number of installed Licenses [0-65535]
Number of programed IP Ports [0-65535]
Note 3
Note 3:
The total number of IP terminals programed for each device listed below will be indicated for Hard
Phone Type-A. “-” will be indicated for other three devices.
• Hard Phone Type-A
• Softphone Type-A
•Standard SIP
• Standard SIP Softphone
Number of registered Licenses [0-65535]
To Next Page
Loading...
