– 764 –
CHAPTER 7 Maintenance Commands
CPCP: Control of PC Port
1. Functional Outline
This command is used when the maintenance personnel disconnects/connects the PC port of DtermIP from/to
the network.
2. Parameters
Input Data
<For the data readout>
Kind of Specification: Select one of the following items:
All Data: Specifies all the DtermIP’s PC ports.
IP Address Specification: Specifies the IP address of DtermIP that has been completed the
Registration process.
STN Specification: Specifies the Tenant Number and Station Number.
TELN (NDM) Specification: Specifies the UGN and Telephone Number (NDM).
TELN (LDM) Specification: Specifies the UGN and Telephone Number (LDM).
IP Address START/END: Specify the range of IP addresses (0.0.0.1 - 255.255.255.254). This parameter
is valid when Kind of Specification = “IP Address Specification”.
TN START/END: Specify the range of IP addresses (0.0.0.1 - 255.255.255.254). This parameter
is valid when Kind of Specification = “STN Specification”.
STN START/END: Specify the range of Station Numbers (Up to six digits (0-9, *, #)).
This parameter is valid when Kind of Specification = “STN Specification”.
UGN START/END: Specify the range of User Group Numbers (1-255). This parameter is valid
when Kind of Specification = “TELN (NDM) Specification” or “TELN (LDM)
Specification”.
TELN START/END: Specify the range of Telephone Numbers (Up to 16 digits (0-9, *, #)).
This parameter is valid when Kind of Specification = “TELN (NDM)
Specification” or “TELN (LDM) Specification”.
To Next Page
Loading...
