– 218 –
CHAPTER 3 System Messages
1-B: TSW Failure (Permanent)
This message displays when link information cannot be written into the switch memory of the TSW card in one
of the dual systems.
TSW system in which a fault is
detected
Status at the time of fault detection
Data Analyzed by NEC Engineers
Reference: See Speech Path System Fault - STBY Side Has Become Fault for the repair procedure.
Default Alarm Default Grade Grade Modified Lamp Modified
MN 3
1: XXXX XXXX XXXX XXXX 2: 0000 0000 0000 0000 3: 0000 0000 0000 0000
4: 0000 0000 0000 0000 5: 0000 0000 0000 0000 6: 0000 0000 0000 0000
7: 0000 0000 0000 0000 8: 0000 0000 0000 0000 9: 0000 0000 0000 0000
b7 b0
b7 b6 b0
1 2
3
1
b0: 0/1 = TSW 0/TSW 1
b6: 0/1 = Speech Path in ACT status
System 0/System 1
2
3
To Next Page
Loading...
