– 823 –
CHAPTER 7 Maintenance Commands
DPKG: Display of Setting Port Package
1. Functional Outline
This command is used to display the circuit card name accommodated in each Group of a specific UNIT.
Note: When using this command, make sure that each circuit card’s related database file has already been in-
stalled to the PCPro. (See the FLINST command for more information.)
Note: DPKG command should be run during low traffic only.
2. Parameters
Input Data
MG: Module Group Number [00-07]
UNIT: Unit Number [0-3]
Buttons
Get: Get information on mounted circuit cards.
Close: Exit this command.
Note: When the Input Data above is entered and the Get button is pressed, the related circuit card name is dis-
played on a Group basis. However, if the name is not found for some reason, the following mark may
appear in the relevant display field.
•# o Unidentifiable firmware type.
•##o Data not found in FMID (database).
•###o Group data not assigned.
•* o Circuit card name not found (for the card is in make-busy state, etc.).
To Next Page
Loading...
