– 808 –
CHAPTER 7 Maintenance Commands
DISI: Display of IP Statistics Information
1. Functional Outline
This command is used to output the statistic information corresponding to the LENS data of the designated
IPELC or IPTRK card.
2. Parameters
Input Data
TYPE: Type of IPTRK Control [1-8]
Select the type from combo box;
1=Internal Ether Traffic Data of IP Trunk Read
2=External Ether Traffic Data of IP Trunk Read
3=Signal Control Traffic Data of IP Trunk Read
4=Voice Control Ether Traffic Data of IP Trunk Data Read
5=IP Trunk Status Read
6=Terminal Data of IPELC Read
7=Traffic Data of IPELC Read
8=Traffic Data of PHG Read (External Ether)
IPTEN: Line Equipment Number of IPTRK (available for TYPE=1-5)
PHGEN: Line Equipment Number of PHG (available for TYPE=8)
DST_IP: IP address of destination IPTRK/PHG (Available for TYPE=3)
LENS: Enter the Line Equipment Number of the IPELC card [six digits] (available for
TYPE=6-7)
KIND: Read Kind (available for TYPE=7)
1=Ether Driver Statistics data of circuit card
2=PROTIMS/RTP Packet Information
DATA CLEAR: Designated kind statistics data of circuit card clear flag (available for TYPE=7-8)
Clear Data/Not Clear Data
To Next Page
Loading...
