NEC UNIVERGE SV8500 - CATK Continuous Assignment of Trunk Data

– 722 –
CHAPTER 7 Maintenance Commands
CATK: Continuous Assignment of Trunk Data
1. Functional Outline
This command can assign/delete many trunk data with consecutive numbers at once.
2. Parameters
Type/KIND: Assign/Delete
When ASSIGN is selected in the TYPE/KIND selection list box
Input Data
RT: Route Number
TK (START): First Trunk Number [1-768]
TK (END): Last Trunk Number [1-768]
STEP: Trunk Count-up Step [1-10]
Note 1
LENS (START): First Line Equipment Number [six digits]
LENS (END): Last Line Equipment Number [six digits]
TN: Tenant Number
RSC: Route Restriction Class [0-15]
Note 2
SFC: Service Feature Class [0-15] Note 2
GROUP (START):First Group Number [0-31]
GROUP (END): Last Group Number [0-31]
LEVEL (START): First Level Number [0-7]
LEVEL (END): Last Level Number [0-7]
TYPE: Count-up Type [1-6]
Note 3
1 = LEVEL o GROUP o UNIT
2 = LEVEL o UNIT o GROUP
3 = GROUP o UNIT o LEVEL
4 = GROUP o LEVEL o UNIT