– 723 –
CHAPTER 7 Maintenance Commands
5 = UNIT o LEVEL o GROUP
6 = UNIT o GROUP o LEVEL
Note 1: In this parameter, specify the size of increment between the consecutive trunk numbers assigned. See
the example below:
Example:
STEP=2
Note 2: Data entry for this parameter is necessary when RT is 901 or 915.
Note 3: TYPE parameter determines how to arrange the trunk data. See Details on Trunk Arrangement TYPE
for details.
Buttons
Execute: Make the input data valid.
Cancel: Cancel the input data.
Exit: Exit this command.
Output Data
TK: Assigned Trunk Number
LENS: Line Equipment Number
STATUS: Data Entry Result
OK=Data Assignment is successful
Note 4
Note 4:
If OK is not displayed (i.e. the data entry is not successful), related error message is displayed here.
INPUT DATA
RESULT
TK(START)=1
A Trunk Number is assigned by increments of 2
or
A Trunk Number is deleted by increments of 2
TK(END)=21
STEP=2
To Next Page
Loading...
